[Lustre-discuss] STONITH - Heartbeat 2.1.4
Crawford, Philip I.
philip.crawford at chevron.com
Fri Jan 22 09:07:36 PST 2010
Thanks - the script is set up according to the instructions here on the
link you sent, but all I seem to get called to it is getinfo-devid from
heartbeat.
The script run fine when called manually, but I can't seem to figure out
why on a status request it calls getinfo-devid and on a reset it also
call the same thing.
-----Original Message-----
From: Dennis Nelson [mailto:dnelson at sgi.com]
Sent: Friday, January 22, 2010 10:56 AM
To: Crawford, Philip I.; lustre-discuss at lists.lustre.org
Subject: Re: [Lustre-discuss] STONITH - Heartbeat 2.1.4
On 1/22/10 10:51 AM, "Crawford, Philip I." <philip.crawford at chevron.com>
wrote:
> Hi all:
>
> I am using luster 1.8.2-RC3 and heartbeat 2.1.4-10 and trying to get
> an external script to STONITH my nodes that are connected to an APC
> rack PDU. I am using heartbeat in version 1 mode and would prefer to
> use an existing external script and have it showing up in the stonith
-L list.
>
>
> All the script requires is a command start stop or status to control a
> port that is pre-programmed in the script (it's partners port).
>
> It is being caled from the ha.cf with:
>
> stonith_host * external/rpower.apc.phil off ngs5011 stonith_host *
> external/rpower.apc.phil off ngs5012
>
> The logs in the ha-log show that the node is trying to reset but all
> it sends is the getinfo-devid request to the script which it also
> sends on a regular status request.
>
> I haven't been able to figure the included external/rackpdu script at
> all so would rather work with this known external script if possible.
>
> Does anyone have any pointers or advice they can give?
Try here:
http://www.linux-ha.org/ExternalStonithPlugins
>
>
> Thanks.
> _______________________________________________
> Lustre-discuss mailing list
> Lustre-discuss at lists.lustre.org
> http://lists.lustre.org/mailman/listinfo/lustre-discuss
More information about the lustre-discuss
mailing list