[Lustre-discuss] Lustre with Juniper switches?

[Klaus Steden]

Hi there,

Has anyone out in the Lustre community set theirs up in an environment that
used Juniper switches? We're testing one out in the lab with ours, and
something about its configuration isn't working. The same setup has been
tested and operated successfully with Extreme, Cisco, and Alcatel, with no
changes to the Lustre setup itself.

I'm thinking it's more than likely not the Lustre setup, but something about
the switch configuration - VLAN membership, IGMP config, etc.

Is there a checklist of required network protocols/behaviours we can use to
verify our switch configuration?

cheers,
Klaus