[Lustre-discuss] lustre can not mounted problem

[Changer Van]

On Jan 8, 2008 1:35 AM, Isaac Huang <He.Huang at sun.com> wrote:

> On Mon, Jan 07, 2008 at 06:20:52PM +0800, Changer Van wrote:
> >    ......
> >    # dmesg
> >
> >    LustreError: 4273:0:(viblnd.c:1890:kibnal_startup())
> >
> >             Can't find an active port on InfiniHost_III_Ex0
>
> It meant that viblnd couldn't find a port whose link state was active
> on the hca InfiniHost_III_Ex0, i.e. no link on the device was usable.
>
> Was there any other error messages from viblnd before this one?

There was no error messages but a related message
like 'ADDRCONF(NETDEV_UP):ipoib0: link is not ready'.

> Did you see this problem on just one node?

There are four nodes which can not mount the lustre system.
The other nodes can mount the lustre but got the following error messages:

# dmesg
divert: not allocating divert_blk for non-ethernet device ipoib0
ERROR   : IPOIB_UD : ipoib_ud_find_dev_by_dst:(ipoib_ud_arp.c):
     ip_route_output_key(127.0.0.1) failed
new: ipoib_allow_arp_joins: 1
ERROR   : IPOIB_UD : ipoib_ud_find_dev_by_dst:(ipoib_ud_arp.c):
     ip_route_output_key(11.0.0.4) failed
ERROR   : IPOIB_UD : ipoib_ud_find_dev_by_dst:(ipoib_ud_arp.c):
     ip_route_output_key(11.0.0.4) failed
ERROR   : IPOIB_UD : ipoib_ud_find_dev_by_dst:(ipoib_ud_arp.c):
     ip_route_output_key(11.0.0.4) failed

How can I check the link on the device? Thanks in advance.

-- 
Regards,
Changer
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.lustre.org/pipermail/lustre-discuss-lustre.org/attachments/20080108/db9a4b14/attachment.htm>