[Lustre-discuss] Lustre Client using 10GigE iWarp
Liang Zhen
Zhen.Liang at Sun.COM
Mon Jun 1 03:31:22 PDT 2009
David Dillow wrote:
> On Fri, 2009-05-29 at 08:57 -0500, Dennis Nelson wrote:
>
>> I have tried this:
>>
>> options lnet networks=o2ib(eth2)
>>
>> Is that correct?
>>
>
> I would think so, but someone more experienced in the Lustre o2ib LND
> and iWarp should chime in on that -- I've never used iWarp, only IB.
>
we also need this for iWarp:
options o2iblnd map_on_demand=64
or map_on_demand=32 if you failed to startup
Regards
Liang
>
>> The client is connected to the IB fabric using a Voltaire 10 GigE line card
>> on a IB switch. Has anyone tested such a configuration? Should I expect it
>> to work?
>>
>
> I don't expect that to work, unless the Voltaire is converting iWarp to
> IB -- and I highly doubt that. It is more likely using EoIB to transport
> the ethernet frames over the IB fabric. You will likely need a Lustre
> router to sit between the two fabrics.
>
More information about the lustre-discuss
mailing list