[Lustre-discuss] Help! Newbie trying to set up Lustre network

[Bob Ball]

Make sure that the kernel you are running matches up with the rpms you 
installed then?

[ball at umt3int01:gate01_b]$ rpm -qa|grep lustre
lustre-client-1.8.4-2.6.18_194.17.4.el5.x86_64
lustre-client-modules-1.8.4-2.6.18_194.17.4.el5.x86_64
[ball at umt3int01:gate01_b]$ uname -r
2.6.18-194.17.4.el5

bob

On 2/22/2011 3:03 PM, Xiang, Yang wrote:
> But my mount command is failing and that's the issue:
> mount -t lustre 192.168.0.2 at tcp0:/temp /lustre
> mount.lustre: mount 192.168.0.2 at tcp0:/temp at /lustre failed: No such
> device
> Are the lustre modules loaded?
> Check /etc/modprobe.conf and /proc/filesystems
> Note 'alias lustre llite' should be removed from modprobe.conf
>
> And yes I created the /lustre mount point.
>
> And I tried to add to the fstab to avoid "sunrpc" to take over on boot.
>
> This is frustrating...
>
> Thanks,
>
> Yang
>
>
> -----Original Message-----
> From: lustre-discuss-bounces at lists.lustre.org
> [mailto:lustre-discuss-bounces at lists.lustre.org] On Behalf Of Brian J.
> Murrell
> Sent: Tuesday, February 22, 2011 11:58 AM
> To: lustre-discuss at lists.lustre.org
> Subject: Re: [Lustre-discuss] Help! Newbie trying to set up Lustre
> network
>
> On 11-02-22 02:55 PM, Xiang, Yang wrote:
>> On the client, I only did:
>> "rpm -ivh
>>
> lustre-client-modules-1.8.52.6.16_60_0.69.1_lustre.1.8.5_smp.x86_64.rpm"
>> And
>> "rpm -ivh
>> lustre-client-1.8.5-2.6.16_60_0.69.1_lustre.1.8.5_smp.x86_64.rpm"
> That's fine.
>
>> Lsmod does not show any lustre modules getting loaded.
> Even after you run "mount -t lustre ..."?
>
>> Do I need to do an "insmod" of some top level client ko? The
>> installation guide does not say anything.
> On a properly configured and working Linux system, no.  The "mount -t
> lustre" command should load the lustre modules.
>
> b.
>