[Lustre-discuss] Lustre missing physical volume
Mark Day
mark.day at rsp.com.au
Sun Jul 1 18:10:49 PDT 2012
Does the device show up in /dev ?
Have you physically checked for Fibre/SAS connectivity, RAID controller errors etc?
You may need to supply more information about your setup. It sounds more like a RAID/disk issue than a Lustre issue.
----- Original Message -----
From: "David Noriega" <tsk133 at my.utsa.edu>
To: lustre-discuss at lists.lustre.org
Sent: Monday, 2 July, 2012 8:51:18 AM
Subject: [Lustre-discuss] Lustre missing physical volume
Just recently used heartbeat to failover resources so that I could
power down a lustre node to add more ram and failed back to do the
same to our second lustre node. Only then do I find that now our
lustre install is missing a physical volume out of lvm. pvscan only
shows three out of four partitions.
Any hints? I've tried some recovery steps in lvm with pvcreate using
the archived config for the missing pv but no luck, says no device
with such uuid. I'm lost on what to do now. This is lustre 1.8.4
_______________________________________________
Lustre-discuss mailing list
Lustre-discuss at lists.lustre.org
http://lists.lustre.org/mailman/listinfo/lustre-discuss
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.lustre.org/pipermail/lustre-discuss-lustre.org/attachments/20120702/92f14054/attachment.htm>
More information about the lustre-discuss
mailing list